Heat pumps · Chillers · Sludge drying systems
Frequently asked questions

Answers to the questions that decide selection and delivery

Frequently asked questions by product system, based on LONGCOM technical articles and project practice. For a project-specific answer, send the duty conditions directly.

Heat pump · Hot water · Heating · Cooling

Air-source heat pump systems

Explore system →
Can a heat pump deliver 60 °C reliably in winter

At −5 °C ambient, most units reach 55–60 °C with reduced capacity. Specify an immersion top-up for the final 5–10 K so the tank always reaches 60 °C, and size the heat pump on the 55 °C duty.

Read the full technical article →
Is a separate circuit for theatres really necessary

Yes. Theatres need assured temperature, no interruption and often filtered water. Sharing a circuit with the laundry means a laundry peak can affect a scrub sink.

Read the full technical article →
How much storage should a hospital hold

Enough for the peak plus one disinfection cycle: typically 20%–30% of daily demand for wards, and one full day for CSSD. Storage also provides the buffer that lets the plant run at a steady load.

Read the full technical article →
What documentation does a hospital project need

A water safety plan, schematic with dead legs, temperature monitoring schedule, commissioning records for every circuit, and a validation report for the legionella regime. Expect the estate team to audit all of it.

Read the full technical article →
Industrial cooling · Process

Industrial cooling systems

Explore system →
Which is more reliable

Both are mature. Screw machines tolerate abuse better and are simpler to service; centrifugal machines have fewer moving parts in the compressor but need surge protection and, in oil-fed designs, careful oil management.

Read the full technical article →
Can a centrifugal run at 10% load

Most cannot without hot gas bypass, which wastes energy. Below 20%–30%, a smaller machine or a screw is the better answer.

Read the full technical article →
Is a magnetic bearing chiller worth the premium

Where maintenance access is difficult, where oil contamination is unacceptable, or where part-load efficiency is the priority. The premium is typically 15%–30% and is recovered through efficiency and maintenance.

Read the full technical article →
How does refrigerant choice affect the decision

Large centrifugal machines historically used low-pressure refrigerants; modern designs use HFCs or HFOs with different charge sizes and safety classifications. Check the charge against local refrigerant regulations.

Read the full technical article →
Drying · Reduction · Integrated

Sludge drying systems

Explore system →
What cake solids should I design for

Use the measured value from the actual press and sludge, not the catalog. If the press is not yet installed, use a pilot test or a conservative figure 2–3 points below the brochure.

Read the full technical article →
Is lime conditioning compatible with drying

It works but it is inefficient: lime adds mass that has to be heated and reduces the organic content. Use it only if the downstream route requires pH adjustment.

Read the full technical article →
How big should the cake buffer be

Eight hours of production is the normal minimum; 24 hours gives much more flexibility and is worth the space in a plant that runs a single shift.

Read the full technical article →
Can the dryer take cake directly from the press

Yes, with a buffer and a variable-speed feeder. Direct feeding without a buffer causes the dryer to cycle and the product moisture to vary.

Read the full technical article →