Technical articles
Technical articles, sizing methods and O&M notes by product line.
Frost Build-Up and Filter Blockage on a Heat-Pump Sludge Dryer
Why frost forms on a heat-pump sludge dryer evaporator, how each defrost method works, and the filter and coil cleaning schedule that keeps capacity at design.
Odor and Condensate from Sludge Drying: What to Do With Both
Where odor and condensate come from in a heat-pump sludge dryer, how to size a biofilter or scrubber, and how to characterize and discharge the condensate.
Which Sludges Can a Heat-Pump Dryer Handle?
Sludge types that dry well at 40–80 °C, the ones that do not, and the seven laboratory tests that decide suitability before a dryer is specified.
Sludge Drying Investment Payback: How to Build the Case
A worked payback calculation for a 10 t/day sludge dryer, the sensitivities that decide the outcome, and the costs that are usually left out of the case.
How Does a Sludge Dryer Work? Low-Temperature Drying and Dehumidification
How heat-pump sludge dryers remove water at 40–80 °C: the closed-loop dehumidification cycle, why low temperature matters, and what the process does and does not achieve.
How Low Can a Sludge Dryer Take the Moisture Content?
Final moisture targets by disposal route, why 10% is not always better than 30%, the stickiness zone that limits drying, and the mass balance for each target.
Sludge Dryer Energy Consumption and Operating Cost
Specific energy per tonne of water evaporated, a full cost calculation for a 10 t/day plant, why the figure varies, and how to reduce it.
How Much Does a Sludge Dryer Cost?
Indicative prices from 1 to 50 t/day, the seven cost lines in a dryer quotation, and how to compare offers that use different capacity units.
Sludge Dryer Throughput Below Design: How to Find the Cause
Why a heat-pump sludge dryer falls short of rated throughput, the mass balance that identifies the cause, and the six checks in the order that finds it fastest.
Uneven Drying and Wet Patches: Why They Happen and How to Fix Them
Why a sludge dryer produces wet patches, the loading, airflow and stickiness causes, and the mechanical and operational fixes that bring moisture variation within ±3 points.